First hollow stem.
First hollow stem.

Wheat is developing rapidly now and is earlier than normal in much of Kansas. Producers should start examining plants now to determine if the wheat has reached the “first hollow stem” (FHS) stage. This stage occurs as the wheat switches from the vegetative stage to the reproductive stage of growth.

When the leaf sheaths become strongly erect, the growing point, which is below the soil surface, will soon begin to develop a tiny head. Although the head is quite small at this point, it has already established some important yield components. At this stage, the maximum potential number of spikelets is determined. Sufficient nitrogen (N) should already be available in the root zone at growth stage in order to affect the potential number of seeds per head.

Once the embryo head has developed, the first internode will begin to elongate pushing the head up through the leaf sheaths. This first internode will be hollow. This will be visible before you can actually feel the first node (joint, located just above the first internode). Prior to this stage the nodes are all formed but tightly packed together and hard to see.

FHS is the point at which a half-inch or so of hollow stem can first be identified above the root system and below the developing head. FHS occurs when the developing head is still below the soil surface, which means that producers have to dig plants out of the ground to do the examination.

To look for FHS, start by digging up some plants from fields that have not been grazed. Select the largest tillers to examine. Cut off the top of the plant, about an inch above the soil surface. Then slice the stem open from the crown area up. Look for the developing head, which will be very small. Next, see if you can find any hollow stem between the developing head and the crown area. If there is any separation between the growing point and crown, the wheat plant is at FHS. FHS will occur between a few days and a week or more prior to jointing, depending on temperatures.

If the wheat has reached FHS, cattle should be removed to prevent grain yield loss. Yield losses from grazing after FHS may be up to 1.25 bushels per day according to OSU data, although losses may not be this great for the first few days of grazing after FHS. Still, it is easy for producers to be late by a few days in removing livestock as they wait for obvious nodes and hollow stems to appear, and even the first few days can be significant.

Two things are observed when wheat is grazed too long: 1) fewer heads per acre because the primary tiller has been removed and 2) smaller and lighter heads than expected because leaf area has been removed. As cattle continue grazing, the wheat plant is stressed and begins to lose some of the tillers that would produce grain. A little later, if there is not enough photosynthate, the plant begins aborting the lower spikelets (flowers where seed develops) or some of the florets on each head. Finally, if there is not enough photosynthate during grain filling, the seed size will be reduced and if the stress is severe enough, some seed will abort.