Dormant seeding wheat research data released

decrease font size  Resize text   increase font size       Printer-friendly version of this article Printer-friendly version of this article


The Dakota Lakes Research Farm as part of the South Dakota State University agricultural research system has focused more than three decades of research on dormant seeding of wheat. Dwayne Beck, research manager, is sharing a summary of the research.

"Dormant seeding is when a crop is placed in a soil long before soil temperatures and/or moisture conditions are going to allow the seed to germinate and grow. This technique is commonly used for plants like native grasses and forbs. It is less common with grain crops," Beck said.

Beck said growers should consider this technique to assure early seeding of cool-season crops like spring wheat, where it is important to avoid hot weather that occurs when they are planted too late in the spring. It also helps to spread workload. He added that in 2012/ 2013 these two factors may be important for growers with large acreages of winter wheat that were not planted in the fall because of dry soil conditions.

"Dormant seeding works best with crops like wheat that keep their growing points below the soil surface (hypogeal) for an extended period after leaf emergence as compared to crops like canola (epigeal) that place their growing points on or above the soil surface as they emerge," Beck said. "Spring frosts can cause extensive damage to crops with epigeal type emergence."

Beck said dormant seeding spring wheat is not a substitute for planting winter wheat at the proper time when conditions are suitable.

"It is a viable alternative to a traditional spring wheat seeding program and as a means to keep wheat in the rotation when dry weather precludes winter wheat seeding in the fall," he said. "I also emphasize to growers that the field needs to have adequate residue. At the present time some of the land that was not seeded to winter wheat because the operator feared it would blow, has not received moisture, so it could still be an issue if those acres were dormant seeded."

A three-year study at the Dakota Lakes Research Farm produced a spring wheat yield of 65.8 bushel per acre (bpa) with dormant seeding and 62.0 bpa with late March seeding. Beck says this slight yield advantage to proper dormant seeding would be larger if the spring seeding was delayed into April.

"Dormant seeded wheat should always be done with spring wheat and not winter wheat," Beck said. "Winter wheat will most likely vernalize and produce heads the next summer when dormant seeded in the fall, but the research at Dakota Lakes indicates that dormant seeded winter wheat heads and matures later than spring wheat seeded the same day and the winter wheat yields are less. The results of a 1999 study (fall of 1998) comparing winter and spring wheat planted at normal, recommended dates with dormant seeded are listed in the table below.

 

1999 Dormant Seeded Wheat Yields

   
 

Dakota Lakes Research Farm

   

--------------

Date

------------------

 

Wheat Type

Planted

Bu/Ac

Variety

W. Wheat

Dec. 11

64.8

AP7510

S. Wheat

Dec. 11

68.4

Russ

S. Wheat

Mar. 19

65.7

Russ

W. Wheat

Sept. 20

100.8

AP7510

 

Beck explains that the small difference between the December and March seeding of spring wheat indicates that the primary reasons for considering the technique are to assure early wheat seeding and to provide more time in the spring for seeding other cool-season crops like canola, peas and flax.

 

"Getting these done early clears the way for timely seeding of the warm-season crops," he said.

 

He says dormant seeding should not be considered in situations where residue and soil conditions will result in increased wind erosion potential.

 

"Good sanitation and rotations practices need to be in place because time and temperature conditions will limit spring burndown options," he said. "Surface residue should be sufficient to minimize soil temperature fluctuations associated with short winter-time warm ups that may cause the wheat to germinate, only to be killed by cold temperatures that could follow."

 

Planting recommendations

Seeding should occur after soil temperatures have cooled sufficiently to prevent the seed from germinating. If possible, it should be done just before the soil freezes. Cold soil that is dry will seed well. If the soil is moist and frozen it is sometimes not possible to seed at normal (1 to 1.5 inches) seeding depth. Shallow seeding will fail. The proper time at Pierre is usually the week following Thanksgiving but this can vary. A normal seeding rate (1.6 million pure live seeds/acres) or slightly higher is appropriate. Treating the seed with a fungicide seed treatment has been beneficial. Placing dry fertilizer (50 to 70 lbs of 11-52-0/acre) was used in these trials and was also beneficial. Higher rates, inclusion of chloride fertilizers, and liquid fertilizer sources in contact with the seed were not tested. These may create concern.

 

Insurance considerations

There are some very gray areas in crop insurance regulations when the subject of dormant seeding is involved. Beck says his personal optimistic interpretation is that early December is actually very early spring. He recommends that all growers check with their insurance provider.

 

Biggest drawback to dormant seeding

The biggest drawback to dormant seeding is the need to pull things out of the shed and get them ready to go at this time of year. Everyone wants to relax and get ready for the holidays. The days are short and the weather can be cold. Heated cabs and auto steer are a huge benefit as compared to 15 years ago but it still takes discipline. Dormant seeding is the normal practice for spring wheat production at Dakota Lakes.


Buyers Guide

Doyle Equipment Manufacturing Co.
Doyle Equipment Manufacturing prides themselves as being “The King of the Rotary’s” with their Direct Drive Rotary Blend Systems. With numerous setup possibilities and sizes, ranging from a  more...
A.J. Sackett Sons & Company
Sackett Blend Towers feature the H.I.M, High Intensity Mixer, the next generation of blending and coating technology which supports Precision Fertilizer Blending®. Its unique design allows  more...
R&R Manufacturing Inc.
The R&R Minuteman Blend System is the original proven performer. Fast, precise blending with a compact foot print. Significantly lower horsepower requirement. Low inload height with large  more...
Junge Control Inc.
Junge Control Inc. creates state-of-the-art product blending and measuring solutions that allow you to totally maximize operating efficiency with amazing accuracy and repeatability, superior  more...
Yargus Manufacturing
The flagship blending system for the Layco product line is the fully automated Layco DW System™. The advanced technology of the Layco DW (Declining Weight) system results in a blending  more...
Yargus Manufacturing
The LAYCOTE™ Automated Coating System provides a new level of coating accuracy for a stand-alone coating system or for coating (impregnating) in an automated blending system. The unique  more...
John Deere
The DN345 Drawn Dry Spreader can carry more than 12 tons of fertilizer and 17.5 tons of lime. Designed to operate at field speeds up to 20 MPH with full loads and the G4 spreader uniformly  more...
Force Unlimited
The Pro-Force is a multi-purpose spreader with a wider apron and steeper sides. Our Pro-Force has the most aggressive 30” spinner on the market, and is capable of spreading higher rates of  more...
BBI Spreaders
MagnaSpread 2 & MagnaSpread 3 — With BBI’s patented multi-bin technology, these spreaders operate multiple hoppers guided by independent, variable-rate technology. These models are built on  more...


Comments (0) Leave a comment 

Name
e-Mail (required)
Location

Comment:

characters left


NORAC UC4.5™ & UC5™ Precision Spray Height Control

NORAC offers two Spray Height Control systems that can be installed on most sprayer models. UC5™ is an ISOBUS system ... Read More

View all Products in this segment

View All Buyers Guides

Feedback Form
Feedback Form