Source: Stephen Wegulo, Extension Plant Pathologist and Dewey Lienemann, Extension Educator, University of Nebraska

As of May 18, stripe rust was widespread in south central and southeast Nebraska based on a survey of wheat fields and phone or e-mailed reports.

A survey of fields in south central Nebraska on May 18 found severity of stripe rust ranging from low to more than 70 percent. Field symptoms varied, ranging from no visible symptoms to isolated spots showing yellow leaves to large affected areas. In one field, there was a sharp contrast between a susceptible variety and one planted next to it that appeared to have some resistance.

Responding to Stripe Rust
Stripe rust can cause 100 percent loss to a wheat crop. This year's prolonged cool, wet weather has favored and continues to favor development and spread of this disease.

If you see stripe rust in your field, apply a fungicide to protect the flag leaf. This recommendation extends to varieties known to be resistant. They can still suffer damaging levels if a new race of stripe rust is present. If your wheat is headed and or is beginning to flower, apply a fungicide that has good to excellent efficacy against both stripe rust and Fusarium head blight (scab).

Fungicide Efficacy for Control of Wheat Diseases
The North Central Regional Committee on Management of Small Grain Diseases (NCERA-184) has developed the following information (Table 1) on fungicide efficacy for control of certain foliar diseases of wheat. The table is compiled and continually updated by the committee as new data becomes available.

Efficacy ratings for each fungicide were determined by committee members field testing the materials over multiple years and locations. Efficacy is based on proper application timing to achieve optimum effectiveness of the fungicide as determined by labeled instructions and overall level of disease in the field at the time of application. Differences in efficacy among fungicide products were determined by direct comparisons among products in field tests and are based on a single application of the labeled rate as listed in the table. The table includes the most widely marketed products, and is not intended to be a list of all labeled products.