Fall strip tillage systems: An introduction
Strip tillage is a relatively new soil conservation system useful for today’s farmers. In Ohio it is most often used as part of a no-till system to increase corn yields.
No-till soybean production continues to increase, but corn grown with no-till and other conservation tillage systems peaked about 1995 and is declining. The main problem is cold, wet soil at planting which delays planting and decreases yield.
What is Strip Tillage?
Strip Tillage is a system combining the benefits of no-till and full-width tillage. Strip tillage is usually performed in the fall following soybeans or wheat to prepare the ground for corn planting. Tillage is confined to narrow strips where seeds will be planted.
The loosened soil in the strip creates a ridge 3 to 4 inches high, which improves soil drainage and warming. By spring, it usually settles down to 1 to 2 inches high, and after planting the field is flat.
Row middles are untilled and covered with undisturbed crop residue. Fertilizer can also be applied during strip tillage.
Why do Strip Tillage?
No-till corn production has not been successful on many flat, poorly drained soils in Ohio. Fall strip tillage is a good alternative to plowing.
Benefits of strip tillage
- soil conservation–undisturbed residue between corn rows (maintains long term no-till benefits)
- improved soil conditions–for development of corn plant in row (warmer, mellow seed bed)
- banding of fertilizer–placing nutrients near crop roots may allow reduced rates
- optimized planting conditions–earlier planting, less need for starter fertilizer
There are many variations of strip-till equipment, but the following is typical: row cleaner, coulter, tillage shank, and ‘covering’ disks. All components are mounted on a tool bar equipped with row markers. It must be the same width as the corn planter, or multiple thereof, because the planter will run precisely where the strips are placed.
Fertilizer is often applied during strip tillage in liquid or dry form. Anhydrous ammonia nitrogen with stabilizer can also be injected during strip tillage. Approximately 15 to 20 horsepower per row is needed for tractor power requirements.
- A row cleaner is important in heavy residue to create a bare soil zone.
- A coulter cuts through any remaining residue.
- The tillage shank, often with a mole knife, is narrow with a small wing near the bottom to enhance soil loosening and deep fertilizer placement with minimal topsoil disturbance. Tillage depth can vary from 4 to 8 inches depending on horsepower available and desired fertilizer placement.
- A pair of disk blades is positioned to catch any soil thrown up by the shank to keep all soil within the narrow strip. The loosened soil forms a small ridge. The disk blades should not run into the soil because a valley may be created on each edge of the strip, which could collect runoff and lead to erosion.
- Fertilizer delivery systems may include:
–Dry P & K air caddy
–Liquid fertilizer tanks
–Anhydrous Ammonia pull-behind wagon
Self-contained hydraulic system with power cables (hydraulic). Tandem Henschen axles (hydraulic). Hydraulic fenders. Manual or hydraulic tilt. 6,500-gallon tank.
- Are you in favor of a federal labeling standard for food that might contain genetically modified ingredients?
- Commentary: Barking up the wrong tree
- Water allocation for most drought-stricken Calif. farms to end
- Look at how the rice scheme made Thailand unstable
- Larson Electronics offers 150 Watt LED high bay light fixture
- Growth Points: Big data is about to get even bigger
Fertilizer Conveying Systems
Waconia Manufacturing Inc.