Evaluation of foliar fungicides, insecticides on soybean
click image to zoom Iowa State University personnel assessed foliar fungicide and insecticide use on soybeans at seven locations across Iowa (Fig. 1) including the Northwest Farm (Sutherland), Northern Farm (Kanawha), Northeast Farm (Nashua), Curtiss Farm (Ames), Armstrong Farm (Lewis), McNay Farm (Chariton) and Southeast Farm (Crawfordsville).
Materials and methods
The experimental design at each location was a randomized complete block with four replications. Details on variety and date of planting, pesticide application and harvest are listed in Table 1. Fungicides and insecticides were applied with a self-propelled research sprayer (Fig. 2) at growth stage R3 (beginning pod) at all seven locations unless otherwise noted. Disease was assessed when soybeans were at the R6 (full seed) growth stage.
click image to zoom Diseases found included Septoria leaf blight (brown spot) in the lower canopy and small amounts of downy mildew and soybean vein necrosis virus in the upper canopy. Only diseases that had more than 1 percent severity were analyzed and included in this report. Although soybean aphid populations were observed between R3 and R6, none of the seven locations reached threshold. Thus, an IPM insecticide treatment for soybean aphid was never applied. Total seed weight per plot and seed moisture were measured with a 2009 Almaco SPC20 research plot combine. Seed weight was adjusted to 13 percent moisture and yield was calculated. click image to zoom
This growing season had less than average rainfall, similar to 2012. Figure 3 shows drought conditions in the United States in early August. While it was abnormally dry across much of Iowa, there were parts that did catch timely rains, especially in the northeast portion of the state.
click image to zoom The dry weather conditions contributed to lack of foliar disease development at any location. The only fungal disease with more than 1 percent severity in the plots was Septoria brown. This low level of disease was not severe enough to affect yield at any location. Soybean vein necrosis virus and soybean green stem syndrome were also identified at several locations.
The majority of fungicide and insecticide treatments had minimal or no effect on seed moisture.
click image to zoom Yield averaged between 45.4 – 71.7 bu/A across locations. Yield response to fungicide, insecticide and fungicide plus insecticide application was minimal at all locations. There were both negative and positive responses to various treatments at some locations, but nothing consistent over the seven locations (Fig. 4). The average yield response for all fungicides across all locations was 0.6 bu/A. The average yield response by chemical family is reported in Figure 5. SkyRaider™ insecticide alone averaged 2.6 bu/A greater than the untreated control and was the only stand-alone insecticide in the trial. We did not see an additive effect for fungicide + insecticide as yield response for these treatments averaged 2.2 bu/A greater than the untreated control across all seven locations. click image to zoom
Self-contained hydraulic system with power cables (hydraulic). Tandem Henschen axles (hydraulic). Hydraulic fenders. Manual or hydraulic tilt. 6,500-gallon tank.
- Dry weather, biofuel mandate to boost palm prices in 2014
- 2014 Farm Bill: Reallocating base acreage
- FAS administrator talks world ag export situation
- The Beige Book is out. The agriculture picture is not rosy
- New precision potassium fertilizer from AgroLiquid
- Ag markets ended the week in decidedly mixed fashion
- Are you in favor of a federal labeling standard for food that might contain genetically modified ingredients?
- Commentary: Barking up the wrong tree
- Water allocation for most drought-stricken Calif. farms to end
- Larson Electronics offers 150 Watt LED high bay light fixture
- Growth Points: Big data is about to get even bigger
- Update on the world’s 15 largest seed banks
Vertical Floor Blenders