Applying UAN and residual herbicides on emerged corn
An early May snow followed by frequent rains throughout most of May have significantly delayed corn planting as well early season field operations such as fertilizer and herbicide applications. This year many corn fields in Nebraska were planted before nitrogen or pre-plant/pre-emergence herbicides had been applied.
At this point, urea ammonium nitrate (UAN) is the preferred nitrogen source because it's a liquid can be applied easily and quickly, and placed more precisely than other nitrogen sources. UAN is a combination of urea and ammonium nitrate and has an N content of 28-32%. The safest application method is to knife in UAN between the rows, but broadcast application is possible if the total nitrogen rate is kept to around 60 lb N per acre. An exact “safe” level of nitrogen is difficult to predict since environmental and corn plant conditions at application affect crop response. Early leaf burn on corn usually is not a lasting problem since the growing point is still underground and a very small amount of total leaf area is exposed (Figures 1 and 2).
Early season weed control is imperative to maximize corn yield. Due to wet soil conditions, many corn growers were not able to apply residual herbicides prior to corn emergence; however, several residual herbicides labeled in corn can be applied after corn emergence. Two important factors to consider when addressing weed control with residual herbicides applied after corn emergence are tank mix partner and carrier options. Applying herbicides and UAN at the same time in a tank mix for corn may seem like a good way to save time and a trip across the field; however, this enhances the foliar activity of herbicides and may result in significant foliar damage to young corn plants.
Several residual herbicides such as Degree Extra, Harness Extra, Keystone, and TripleFlex are labeled for preemergence application in corn with 28% UAN as a carrier option. However, it is not recommended that UAN be used as a carrier when Keystone and TripleFlex are being applied postemergence due to the potential corn injury.
Several other residual herbicides (Balance Flexx, Bicep II Magnum, Keystone, Lexar, Lumax, and TripleFlex) are labeled for early postemergence application in corn where UAN is not recommended. Postemergence application of these herbicides with UAN as a carrier will result in corn injury.
Degree Xtra is one of the few residual herbicides labeled for postemergence applications with UAN as a carrier; however, you should be aware of these aspects:
- Temperature should not exceed 85°F within 24 hours of application.
- Some leaf burn may occur.
- Surfactants, crop oil, or other additives are not recommended unless specified.
- See label for specific tank mix restrictions.
Some fertilizer salts, including UAN, can be used as herbicide additives in a small quantity to increase herbicide efficacy; however, this use would not supply much nitrogen relative to the total nitrogen requirement of the crop. A few herbicides, such as Python and Resolve DF, allow mixing UAN as a carrier at 2 quarts UAN per acre when applied after corn emergence; however, they cannot be applied with UAN as the total carrier because excessive corn injury may occur.
- Deere to lay off more than 600 at four U.S. plants
- Slow pace of rail recovery stirs fear of future woes
- The four pillars of seeing opportunities in problems
- WinField introduces Answer Tech and Data Silo
- Ohio’s largest Deere dealer to sell precision drone products
- New DuPont Afforia herbicide introduced for soybeans
- No El Niño in 2014? Drought-weary California in trouble
- Suspected Bt corn rootworm resistance in Pennsylvania
- BioNitrogen to build second fertilizer plant in Texas
- Commentary: Setting the record straight on 'Waters of the U.S.'
- Soybean aphid numbers on the rise
- Solar energy jobs increase, wind power decrease