Presentation about NH3 application
Anhydrous ammonia is a cost effective nitrogen source, but it also brings application and equipment technology concerns, as noted by Mark Hanna, Ph.D., Iowa State University Extension agricultural engineer.
Hanna, among other topics, talked about three major concerns—variation in amount of anhydrous ammonia applied per toolbar knife, speed of application and depth of application. His presentation was made during the University of Missouri Crop Management Conference on Dec. 18 attended by ag retailers, crop consultants and farmers in Columbia, Mo.
“One take home message I want you to get is that anything beyond the old open chamber manifold is a step up in terms of lowering your variation across those manifold outlet ports and getting better application uniformity,” said Hanna.
The goal is anhydrous ammonia equal application flowing from every line going to toolbar knives so there isn’t over application to a few lines. To have enough nitrogen for the crop across the field, additional anhydrous ammonia is often applied with the extra nitrogen going to waste in those over applied rows.
“With the price of nitrogen fertilizer today, about 150 acres will pay for the cost of that higher priced manifold. So, it just doesn’t make much sense to stay with the old open chamber style model. If you do use one, at least plumb them so that you get better distribution through the outlet ports,” the Extension engineer said.
What is driving the anhydrous ammonia through the system is tank pressure. “As temperatures go down we get some fairly low tank pressures and sometimes that can give us problems,” Hanna noted. “As the pressure drops in the system, you can get more of that anhydrous ammonia bubbling off as gas, which is what gives you some of the distribution problems.”
Hanna said he is seeing more anhydrous ammonia going on as a custom application service by ag retailers. This has brought attention to ag retailers needing to apply as many acres as fast as possible with the least expense. Large-scale farmers are trying to do the same in covering as many acres as fast as possible.
“It turns out if we can lower that tractor drawbar pull, we can drive a little faster or we can pull a larger toolbar. So, going a little bit shallower is on people’s minds in order to get over more acres,” he said.
The other thoughts are less pull means using a less expensive lower horsepower tractor to do the application.
- EIA expects global oil consumption to grow in 2014
- Soy, wheat markets surged Tuesday
- Work underway to improve malting barley quality
- Commentary: Water police, part two: EPA proposal won't help ag
- Ukraine-Russia situation apparently boosted wheat futures again
- New and cool thought-leadership opportunities with LinkedIn
- Commentary: Blame anti-GMO groups for deaths
- Julie Borlaug says biotech is necessary in fight against hunger
- What does “sustainable” food and agriculture really mean?
- Climate change will reduce crop yields sooner than we thought
- Ohio bill to require certification to apply fertilizer
- Carbon-dioxide hurts nitrogen assimilation by plants