Fall soil testing
Fall is by far the best time to take soil samples. You will have more time to sample properly than in the spring. You will have time to really think about the results and make plans for next year, which might include early ordering of fertilizer, deciding where manure might be most beneficial, etc. Soil and weather conditions are often better for sampling in the fall. You cannot afford to have your crop come up short because of lack of nutrients when you are making a significant investment in the many inputs required to put out the crop. At the same time, you cannot afford to apply extra nutrients that will not give you an economic return. The economics of soil testing are pretty simple. If you sample a 10A field every 3 years as recommended, the cost per acre is around $0.30/A/year. This very small investment in soil testing which results in recommendations that are used to manage typically more than $200 worth of nutrients on a crop that is worth over $1000/A. You can’t risk this magnitude of input costs and potential returns on a guess.
Good soil test begin with good soil samples. Here are some guidelines for getting good soil samples.
- Sample uniform areas
Usually we sample each field individually. However, there may be times when we need to subdivide fields if there is the potential for significant differences across the field. Examples include: significant soil differences, part of the field receives manure but not the whole field, topographic differences such as low areas versus sidehills, etc. Also, there are situations when we can combine fields. For example when we have small strips that are all managed the same we can lump these together into one sample.
- Take lots of cores
At least 15 to 20 cores should be collected to make up a composite sample to send to the lab. More is better.
- Sample to uniform depth
For most routine soil testing samples should be collect to plow depth. Even in no-till or permanent sods. Inconsistent sampling depth is one of the biggest sources of errors in soil sampling. This is especially true in no-till and reduced tillage systems where there is often significant stratification of nutrients in the soil.
Special note in no-till: In no-till fields an acid layer, called an acid roof, can develop right at the surface of the soil. This thin acid layer can have a significant impact on the crop but it can be missed in a normal plow depth sample. If the normal plow depth soil sample in no-till recommends liming, apply the lime as recommended and no further testing is needed. If the normal sample does not recommend lime and the field has been in long-term no-till and has not been limed recently, take a less than 2 in. deep sample and test it for pH. This sample can be submitted to a soil testing lab or you can use a field pH test kit for this purpose. If this sample has a pH less than 6.2, then apply 1 ton of limestone even if the regular sample soil test did not call for any limestone.
- Avoid atypical areas or sample them separately
- New calculator can help soybean farmers with seed decisions
- U.S., Brazil close to ending cotton trade rift
- U.S.-Japan trade talks hit new farm exports snag
- Ag markets posted a general comeback Wednesday
- Midwest grain growers ‘Invest an acre to feed the world’
- Ag markets turned mixed around midsession Wednesday
- Activists fighting Golden Rice even more in 2014
- U.S. GMO labeling foes triple spending in first half of this year
- Source shows half of GMO research is independent
- White House issues veto threat on bill to block WOTUS rule
- East-West Seed signs marketing collaboration with Monsanto
- How much corn can the ethanol industry use?