Difficult to anticipate Dec. 1 corn stocks estimate

decrease font size  Resize text   increase font size       Printer-friendly version of this article Printer-friendly version of this article

The USDA’s estimate of Dec. 1, 2012, inventories of corn, to be released on Jan. 11, 2013, will be one of the more important factors influencing the price of old-crop corn in the first quarter of the new year. The estimate of soybean stocks may be somewhat less important because more is known about the level of consumption during the first quarter of the 2012-13 marketing year, according to University of Illinois agricultural economist Darrel Good.

“For soybeans, consumption during the first quarter of the marketing year is generally known because periodic export and crush estimates are available,” Good said. “Based on Census Bureau estimates for September and October and USDA inspection estimates through November, exports were near 613 million bushels. That would be slightly less than the record-large exports of two years ago. Based on estimates from the National Oilseed Processors Association, the domestic crush during the first quarter was near 448 million bushels, the largest in five years,” he said.

Good continued, saying that feed, seed, and residual use during the first quarter is highly variable but averaged 115 million bushels in the previous 10 years. Total consumption during the quarter was likely near 1.176 billion bushels. The biggest uncertainty about the magnitude of Dec. 1 stocks is the size of the 2012 harvest. “If the final estimate of crop size is near the November forecast, Dec. 1 stocks would have been near 1.97 billion bushels, 400 million smaller than the inventory of a year earlier. As indicated in an earlier Weekly Outlook, previous years with yield forecasts following the pattern of 2012 provide little direction for forming expectations about the January yield estimate this year,” he said.

According to Good, the magnitude of corn stocks on Dec. 1 will reveal the magnitude of consumption during the first quarter of the marketing year and the amount of corn available for consumption during the final three-quarters of the year. In essence, the stocks estimate will reveal whether the small 2012 crop is being sufficiently rationed. The magnitude of stocks will be influenced by the final estimate of the size of the 2012 crop. Due to the severity of the drought, there is some expectation that the USDA’s December survey revealed fewer acres harvested for grain than was forecast in November. Like soybeans, previous years with corn-yield forecasts following the pattern of 2012 provide little direction for forming expectations about the January yield estimate this year.

“The uncertainty about the final production estimate is one of the factors that makes it very difficult to anticipate the magnitude of Dec. 1 stocks,” Good said. “In addition, the magnitude of stocks will be influenced by the imports of corn during the first quarter of the marketing year. For the year, the USDA has forecast imports of 100 million bushels, compared to about 30 million in each of the previous two years. The Census Bureau, however, reported total imports of only 4 million bushels in the first two months of the year. The magnitude of imports in November is not yet known,” he said.        

Based on Census Bureau estimates through October and USDA inspection estimates through November, exports during the quarter were near 215 million bushels. Exports during the quarter were 190 million bushels less than during the first quarter a year ago and the smallest in 41 years. Based on the estimate of ethanol production during the first quarter of the 2012 corn marketing year, and the assumption that processing for other uses proceeded as forecast by the USDA, total domestic processing use during the quarter was near 1.48 billion bushels. That is 135 million bushels less than use during the first quarter last year.

Good said that the rate of domestic feed and residual use of corn is not known but will be revealed by the magnitude of Dec.1 stocks. Total disappearance during the quarter, minus exports and domestic processing use (estimated here at 1.695 billion bushels), equals feed and residual use.

“Anticipating the level of feed and residual use is difficult because the level of use in that category during the first quarter of the year varies considerably,” Good said. “Implied use varied by 250 million bushels the previous two years and by 565 million bushels in the previous five years.  Use this year is even more difficult to anticipate due to the harvest of an estimated 1.2 billion bushels of corn before the start of the marketing year on Sept. 1. Some of that corn was presumably consumed before Sept. 1, but will be revealed as consumed after Sept. 1. That expectation is supported by the unusually small estimate of corn in the feed and residual category during the final quarter of the 2011-12 marketing year. Even then, Sept.1 stocks of old crop corn were smaller than expected,” he said.

Good concluded that the magnitude of Dec. 1 corn stocks cannot be forecast with confidence and expectations will likely be in a wide range. However, the potential for a smaller 2012 production estimate and a large level of implied feed and residual use point to relatively low inventories and the need to slow the pace of corn feeding. 


Buyers Guide

Doyle Equipment Manufacturing Co.
Doyle Equipment Manufacturing prides themselves as being “The King of the Rotary’s” with their Direct Drive Rotary Blend Systems. With numerous setup possibilities and sizes, ranging from a  more...
A.J. Sackett Sons & Company
Sackett Blend Towers feature the H.I.M, High Intensity Mixer, the next generation of blending and coating technology which supports Precision Fertilizer Blending®. Its unique design allows  more...
R&R Manufacturing Inc.
The R&R Minuteman Blend System is the original proven performer. Fast, precise blending with a compact foot print. Significantly lower horsepower requirement. Low inload height with large  more...
Junge Control Inc.
Junge Control Inc. creates state-of-the-art product blending and measuring solutions that allow you to totally maximize operating efficiency with amazing accuracy and repeatability, superior  more...
Yargus Manufacturing
The flagship blending system for the Layco product line is the fully automated Layco DW System™. The advanced technology of the Layco DW (Declining Weight) system results in a blending  more...
Yargus Manufacturing
The LAYCOTE™ Automated Coating System provides a new level of coating accuracy for a stand-alone coating system or for coating (impregnating) in an automated blending system. The unique  more...
John Deere
The DN345 Drawn Dry Spreader can carry more than 12 tons of fertilizer and 17.5 tons of lime. Designed to operate at field speeds up to 20 MPH with full loads and the G4 spreader uniformly  more...
Force Unlimited
The Pro-Force is a multi-purpose spreader with a wider apron and steeper sides. Our Pro-Force has the most aggressive 30” spinner on the market, and is capable of spreading higher rates of  more...
BBI Spreaders
MagnaSpread 2 & MagnaSpread 3 — With BBI’s patented multi-bin technology, these spreaders operate multiple hoppers guided by independent, variable-rate technology. These models are built on  more...


Comments (0) Leave a comment 

Name
e-Mail (required)
Location

Comment:

characters left


Kinze 1500 Grain Cart

The Kinze 1500 Grain Cart is engineered for speed and reliability required of custom harvesters. Load up to 1500 bushels ... Read More

View all Products in this segment

View All Buyers Guides

Feedback Form
Feedback Form