Moisture sensors are key part of efficient irrigation
If Jason Krutz could put one item on the Christmas list of every row crop farmer in Mississippi, Santa’s elves could not make enough soil moisture sensors to keep up with demand.
Krutz, Mississippi State University irrigation specialist at the Delta Research and Extension Center in Stoneville, wants producers everywhere to approach irrigation with scientific accuracy.
“We’ve been charged by you to make you better irrigators, and the only way we think we can do that is to have you purchase soil moisture sensors and put them in the field,” Krutz told about 400 producers, crop consultants and specialists at the 2013 MSU Row Crops Short Course. “It’s the only way that we can feasibly make you better irrigators.”
Krutz works with the MSU Extension Service and the Mississippi Agricultural and Forestry Experiment Station to support growers with their irrigation needs.
“Up and down the U.S., we irrigate willy-nilly,” Krutz said. “We use a screwdriver to dig down, kick the bed with our boots, maybe take a shovel out and go a few inches deep to look for soil moisture. That’s not going to cut it in the future when we’re running out of water not only in Mississippi but around the globe.”
To both research and demonstrate irrigation efficiency, Krutz uses the Row-crop Irrigation Science and Extension Research, or RISER, program. Through RISER, MSU scientists partner with corn, cotton, soybean and rice producers using existing on-farm management systems to promote good irrigation management practices.
“I’d go to a farmer and say, ‘You give us a 40-acre field and you keep a 40-acre field.’ I have the farmer irrigate according to his regular decision-making process, and I use the tools we have to determine when it was time for irrigation,” Krutz explained.
Fifteen Mississippi producers took part in the RISER program in 2013. In each case, both fields showed similar yields, but the MSU-controlled field used from a quarter to half as much water as the neighboring plot irrigated using traditional decision-making processes.
“It sounds absurd to say that you can apply half the water you normally apply and we can maintain or improve your yield almost guaranteed and improve your profitability by cutting way down on your water cost,” Krutz said.
The tools to make this happen, Krutz said, are soil moisture sensors, surge irrigation and the computerized program Pipe Hole and Universal Crown Evaluation Tool. Known as PHAUCET, this program calculates the proper hole size and distribution for polypipe to furrow irrigate row crops efficiently.
Self-contained hydraulic system with power cables (hydraulic). Tandem Henschen axles (hydraulic). Hydraulic fenders. Manual or hydraulic tilt. 6,500-gallon tank.
- Are you in favor of a federal labeling standard for food that might contain genetically modified ingredients?
- Commentary: Barking up the wrong tree
- Water allocation for most drought-stricken Calif. farms to end
- Larson Electronics offers 150 Watt LED high bay light fixture
- Panama says 'go' to GM mosquito evaluation
- Conference to address “What’s Next for Farmland Values”
Vertical Floor Blenders