Corn consumption continues to exceed projections

decrease font size  Resize text   increase font size       Printer-friendly version of this article Printer-friendly version of this article

Last week’s USDA World Ag Supply & Demand Estimates (WASDE) report projected corn stocks at the end of the current marketing year at 1.331 billion bushels. The year-end projection has declined for five consecutive months, and is now 556 million bushels smaller than the November 2013 projection, according to Darrel Good, University of Illinois ag economist.

Compared to consumption projections made in November, current projections are 100 million bushels larger for corn used for ethanol production, 350 million bushels larger for exports, and 100 million bushels larger for feed and residual use. There have been minor changes in the estimate of stocks at the beginning of the marketing year, the projection of imports, and the projection of other domestic consumption.

With about 4.5 months left in the marketing year, there is opportunity for the consumption projections to change again.

In the case of ethanol use of corn, USDA projects consumption during the current marketing year at 5.0 billion bushels. That projection is 352 million bushels, or 7.6%, larger than consumption in the previous year and equal to consumption in the 2011-12 marketing year.

The reasons for the decline in use last year were outlined in a previous newsletter. Based on monthly U.S. Energy Information Agency estimates of ethanol production for September 2013 through January 2014 and weekly estimates for February and March, ethanol production in the first seven months of the marketing year was 11.7% larger than production during the same period last year. That comparison is a little misleading since year-over-year production was down sharply in the first half of the 2012-13 marketing year and near the previous year's level in the last half.

Still, to reach the USDA projection of corn used for ethanol production this year, ethanol production during the last five months of the corn marketing year needs to be only two% larger than production in the same period last year. With a slight increase in domestic ethanol consumption, an improvement in domestic rail logistics, and a continued positive trade balance, it appears that ethanol production (and therefore corn consumption) could exceed the current projection.

Corn exports during the current marketing year are projected at 1.75 billion bushels. USDA reported cumulative export inspections through the first 31.7 weeks of the year at 991 million bushels.  Official Census Bureau estimates of exports through the first six months of the year exceeded export inspection estimates by 28 million bushels.  If that margin has persisted, exports during the remaining 20.4 weeks of the year will need to total 731 million bushels in order to reach the USDA projection for the year, an average of 35.8 million bushels per week.

Exports have averaged 32.1 million bushels per week so far this year and inspections averaged 46.2 million bushels per week for the seven weeks ended April 10. As of April 3, USDA reported that 707 million bushels of corn had been sold for export, but not yet shipped.  Those sales represent almost 97% of the exports needed to reach the USDA projection. While some sales may be canceled or rolled to next year, it appears there is room for exports to exceed even the most recent USDA projection.

As usual, the most uncertainty about corn consumption centers on the feed and residual category. Uncertainty is fostered by a number of factors.

First, there is no on-going measurement of corn used in the feed and residual category. Implied use is revealed quarterly based on the USDA's quarterly Grain Stocks report.

Second, feed use of corn is influenced by the rate of feeding of other feed ingredients and the use of many of those ingredients is also not measured.

Third, there is not a strong correlation between the number of grain consuming animal units estimated by the USDA and the magnitude of feed and residual use, which implies a varying level of residual use from year to year.

In general, residual use appears to be positively correlated to crop size. For the current year, the USDA projects feed and residual use of corn at a six-year high of 5.3 billion bushels, 22.3% larger than use of last year.

Some have questioned how use can actually increase by over 20% year-over-year. However, estimated use last year was at a 24-year low and likely reflected an abnormally small residual use associated with the very small crop of 2012. The large crop of 2013 would point to much larger residual use this year. In addition, there will likely be considerably less wheat fed this summer than was fed last summer. Most importantly, implied feed and residual use during the first half of the current marketing year was at a six-year high and exceeded that of a year ago by nearly 22%.

The June 1 corn stocks estimate to be released on June 30 will reveal the level of consumption during the third quarter of the year.  For now, the USDA projection of 5.3 billion bushels appears attainable.

Based on current and expected consumption rates, it appears that corn consumption during the current marketing year could exceed the most recent USDA projection. Even if higher rates are confirmed over the next four months, the magnitude of year ending stocks will remain a mystery until the September Grain Stocks report is released on Sept. 30. The magnitude of those stocks will take on a little more importance due to the projected decline in corn acreage this year and what appears will be a slow start to the planting season.


Listen to MP3 podcast

Prev 1 2 Next All

Buyers Guide

Doyle Equipment Manufacturing Co.
Doyle Equipment Manufacturing prides themselves as being “The King of the Rotary’s” with their Direct Drive Rotary Blend Systems. With numerous setup possibilities and sizes, ranging from a  more...
A.J. Sackett Sons & Company
Sackett Blend Towers feature the H.I.M, High Intensity Mixer, the next generation of blending and coating technology which supports Precision Fertilizer Blending®. Its unique design allows  more...
R&R Manufacturing Inc.
The R&R Minuteman Blend System is the original proven performer. Fast, precise blending with a compact foot print. Significantly lower horsepower requirement. Low inload height with large  more...
Junge Control Inc.
Junge Control Inc. creates state-of-the-art product blending and measuring solutions that allow you to totally maximize operating efficiency with amazing accuracy and repeatability, superior  more...
Yargus Manufacturing
The flagship blending system for the Layco product line is the fully automated Layco DW System™. The advanced technology of the Layco DW (Declining Weight) system results in a blending  more...
Yargus Manufacturing
The LAYCOTE™ Automated Coating System provides a new level of coating accuracy for a stand-alone coating system or for coating (impregnating) in an automated blending system. The unique  more...
John Deere
The DN345 Drawn Dry Spreader can carry more than 12 tons of fertilizer and 17.5 tons of lime. Designed to operate at field speeds up to 20 MPH with full loads and the G4 spreader uniformly  more...
Force Unlimited
The Pro-Force is a multi-purpose spreader with a wider apron and steeper sides. Our Pro-Force has the most aggressive 30” spinner on the market, and is capable of spreading higher rates of  more...
BBI Spreaders
MagnaSpread 2 & MagnaSpread 3 — With BBI’s patented multi-bin technology, these spreaders operate multiple hoppers guided by independent, variable-rate technology. These models are built on  more...

Comments (0) Leave a comment 

e-Mail (required)


characters left

Aluminum Grain Trailers

Maurer Manufacturing offers a complete line of high quality aluminum grain trailers. Manufactured in Spencer, Iowa, Maurer aluminum grain trailers ... Read More

View all Products in this segment

View All Buyers Guides

Feedback Form
Feedback Form