Corn and soybean prices searching for support

decrease font size  Resize text   increase font size       Printer-friendly version of this article Printer-friendly version of this article


December 2012 corn futures declined by $1.44 (17 percent) from the high on August 10 to the recent low on September 28. That contract has managed a recovery of about $0.40 so far this month. November 2012 soybean futures declined by $2.85 (16 percent) from the high on September 4 to the low on October 3 and have rebounded about $0.45 since then.

Prices over the past two months for corn and the past month for soybeans appear to be in the classic “short crop, long tail” pattern where prices peak early in a year of sharply lower production and then decline in the post-harvest period as the smaller supplies get rationed and production rebounds in the following year. A change in the trend of lower prices will require an additional supply shock or evidence that supplies have not been sufficiently rationed.

On the supply side for corn, prospects of a bumper crop in China and expectations that production in Argentina will rebound and Brazilian production will remain large in 2013 continue to weigh on U.S. export prospects. Expectations of substantial (75 million bushels or more) imports of corn into the U.S. this year also offset some of the concerns about the shortfall in the U.S. crop. Declining production prospects for the Australian wheat crop and dryness in some U.S. winter wheat areas have not provided much support for corn prices to date. For soybeans, expectations are for a sharp recovery in South American soybean production to record levels in 2013, providing sufficient world supplies in the last half of the 2012-13 marketing year. Declining prospects for the current Canadian canola crop have not resulted in much support for soybean prices. With expectations of very large crops in South America in 2013, some supply shocks are still possible, but there are no immediate threats to those crops.

In the short run, the USDA’s forecast of the size of the U.S. corn and soybean crops to be released on October 11 will be the most important supply information. There are growing expectations that the forecast of the U.S average soybean yield will be increased, adding as much as 175 million bushels to the forecast of crop size. For corn, expectations about crop size are more mixed, with yield expectations running from slightly below the September forecast to as much as 5 bushels above that forecast. The estimate of planted acres is expected to exceed the June estimate, but there is much more uncertainty about the estimate of acreage harvested for grain. The USDA has already indicated that the difference between planted acreage and acreage harvested for grain will be larger than normal, but the October report will provide more information about the likely magnitude of that difference. For both corn and soybeans, history suggests that the October production forecasts will be reasonably close to the final estimates.

For corn consumption, the pace of exports accelerated in September, but remained below the rate needed to reach even the very small USDA forecast for the year. New export sales during September were extremely small so that the magnitude of outstanding sales on September 27 was 42 percent smaller than on the same date last year. Weekly ethanol production during September averaged about 6 percent less than in September 2011, and was 9 percent less in the week ended September 28. Production is running slightly ahead of the pace implied by the USDA’s forecast of a 10 percent reduction in the use of corn for ethanol during the current marketing year. Corn prices got a temporary boost from the USDA’s estimate of September 1 corn stocks that seemed to imply a higher than expected rate of feeding. However, there has been a growing understanding that the stocks estimate revealed little about the pace of corn feeding since so much new crop corn was available before September 1. As a whole, the current pace of corn consumption suggests that the smaller supplies are being sufficiently rationed.

For soybeans, the very rapid pace of export sales has been widely recognized. As of September 27, U.S. export commitments accounted for nearly 82 percent of the USDA’s forecast of exports for the year, with China as the primary buyer. The pace of sales obviously cannot be sustained, but has not yet created concerns of shortages. The expectation of a large South American crop in 2013, ideas that China has already bought more than the usual share of its needs, and the possibility that the U.S. could import soybeans and/or soybean meal next summer if needed imply sufficient supplies. On the domestic side, the estimated size of the soybean crush in September is not yet available.

While corn and soybean prices have declined sharply from their peaks, prices are still very high by any measure. The pace at which prices transition to lower levels will be determined by a number of factors, beginning with the USDA’s October production forecasts.


Buyers Guide

Doyle Equipment Manufacturing Co.
Doyle Equipment Manufacturing prides themselves as being “The King of the Rotary’s” with their Direct Drive Rotary Blend Systems. With numerous setup possibilities and sizes, ranging from a  more...
A.J. Sackett Sons & Company
Sackett Blend Towers feature the H.I.M, High Intensity Mixer, the next generation of blending and coating technology which supports Precision Fertilizer Blending®. Its unique design allows  more...
R&R Manufacturing Inc.
The R&R Minuteman Blend System is the original proven performer. Fast, precise blending with a compact foot print. Significantly lower horsepower requirement. Low inload height with large  more...
Junge Control Inc.
Junge Control Inc. creates state-of-the-art product blending and measuring solutions that allow you to totally maximize operating efficiency with amazing accuracy and repeatability, superior  more...
Yargus Manufacturing
The flagship blending system for the Layco product line is the fully automated Layco DW System™. The advanced technology of the Layco DW (Declining Weight) system results in a blending  more...
Yargus Manufacturing
The LAYCOTE™ Automated Coating System provides a new level of coating accuracy for a stand-alone coating system or for coating (impregnating) in an automated blending system. The unique  more...
John Deere
The DN345 Drawn Dry Spreader can carry more than 12 tons of fertilizer and 17.5 tons of lime. Designed to operate at field speeds up to 20 MPH with full loads and the G4 spreader uniformly  more...
Force Unlimited
The Pro-Force is a multi-purpose spreader with a wider apron and steeper sides. Our Pro-Force has the most aggressive 30” spinner on the market, and is capable of spreading higher rates of  more...
BBI Spreaders
MagnaSpread 2 & MagnaSpread 3 — With BBI’s patented multi-bin technology, these spreaders operate multiple hoppers guided by independent, variable-rate technology. These models are built on  more...


Comments (1) Leave a comment 

Name
e-Mail (required)
Location

Comment:

characters left

chuck    
MN.  |  October, 08, 2012 at 07:07 PM

WHAT HAPPENS WHEN OTHER COUNTRIES STOP BUYING FROM US DUE TO GMO,S ?


Harvest Map Processing™

Features & Options: Farmers harvest fields but they often don’t harvest the data. GEOSYS offers Harvest Map Processing™ as a ... Read More

View all Products in this segment

View All Buyers Guides

Feedback Form
Feedback Form